General Instrument Functions
R&S
®
SMW200A
755User Manual 1175.6632.02 ─ 30
In the "General" tab, you can determine the security level for firmware updates, and
configure the security settings for the mass memory and manual operation.
All modified settings in this dialog are not applied until you enter the Security Password
and confirm with Accept.
12.6.2.1 Update Policy Security Settings
Access:
► Select "System Config > Setup > Security > Security > General > SW Update".
The SW Update tab enables you to select the security mode for firmware updates.
The remote commands available to control security settings are described in Chap-
ter 14.20, "SYSTem Subsystem", on page 1217.
Secure Update Policy
Allows you to configure the automatic signature verification for firmware installation.
To apply the change: enter the security password and confirm with "Accept". Otherwise
the change has no effect.
See also:
●
Chapter 12.6, "Using the Security Settings", on page 752 for more information on
the security concept.
●
The release notes for details on signature verification when installing new or former
firmware versions, available at www.rohde-schwarz.com/firmware/smw200a.
Using the Security Settings
To Next Page
Loading...