Network Operation and Remote Control
R&S
®
SMW200A
799User Manual 1175.6632.02 ─ 30
way are used. With dynamic configuration, DHCP or dynamic link local addressing
(automatic IP) is used to obtain the instrument IP address.
Changing the LAN configuration
This function is password-protected. Unlock the protection level 1 to access it.
Note: We recommend that you change the default password before connecting the
instrument to a network.
How to:
●
"Changing the default user password of the instrument" on page 765.
●
"Changing the default security password" on page 765.
See Chapter 12.6.4, "Password Management", on page 762.
Advanced Config
The "Advanced Config" web page provides LAN settings that are not declared manda-
tory by the LXI standard.
The following advanced parameters are available:
●
"mDNS and DNS-SD": The additional protocols "multicast DNS" and "DNS service
discovery" are used for device communication in zero configuration networks,
working without DNS and DHCP.
●
"ICMP Ping": Must be enabled to use the ping utility.
If you disable this setting, the instrument does not answer ping requests. The set-
ting does not affect the LXI ping client. You can ping other hosts from the instru-
ment, even if the setting is disabled.
●
"VXI-11 Discovery": Must be enabled to detect the instrument in the LAN.
If you disable this setting, the instrument cannot be detected by the VXI-11 discov-
ery protocol mechanism. The setting does not affect other detection mechanisms.
LXI Settings
To Next Page
Loading...