Rohde & Schwarz R&S SMW200A - Page 93

Getting Started
R&S
®
SMW200A
93User Manual 1175.6632.02 ─ 30
1 = Frequency display
2 = Status buttons
3 = Level display
The status buttons indicate key parameters that are set for the output signal. Most of
the status buttons are virtual keys you can use to open a corresponding menu or dia-
log.
For an overview of the status buttons and their functionality, see Chapter C, "Elements
and Controls of the Graphical User Interface", on page 1294.
3.5.3.2 Block Diagram
The block diagram shows the current configuration and the signal flow in the generator
with the aid of function blocks, connected by signal lines.
The following figure displays almost all the elements that can appear in the block dia-
gram. However, it does not necessarily represent a useful configuration.
2
3 4 6
9
10
13
11
12
15
Baseband domain, digital
1
14
RF domain, analog
16
87
5
1, 9, 12, 13, 14
= Connector icons (RF, analog, digital)
2, 11 = Control signal block
3 = Status indicator
4 = Functional block
5, 7 = Graphics indicator
6 = Signal line (digital)
8 = Stream status indicator (On/Off)
10 = Signal line (analog)
15, 16 = Stream indicator (Single, Add)
Starting from left up to the "I/Q Stream Mapper", you can see the functional blocks pro-
vided in the baseband domain. After the stream mapper, the analog section contains
the digital to analog conversion and modulation to RF.
Instrument Control