Remote Control Commands
R&S
®
SMW200A
953User Manual 1175.6632.02 ─ 30
Suffix:
SOURce<hw>
.
1 | 2
Determines the baseband the connectors belong to, where:
SOURce1 = Baseband A/C and
SOURce2 = Baseband B/D
Parameters:
<Level> float
Range: 0.3 to 2
Increment: 0.1
*RST: 1
Manual operation: See "Threshold Clock/Trigger Input" on page 731
[:SOURce<hw>]:INPut:TM:CLOCk:IMPedance <Impedance>
[:SOURce<hw>]:INPut:TM:TRIGger:IMPedance <Impedance>
Selects the input impedance for the external trigger/clock inputs.
Suffix:
SOURce<hw>
.
1 | 2
Determines the baseband the connectors belong to, where:
SOURce1 = Baseband A/C and
SOURce2 = Baseband B/D
Parameters:
<Impedance> G1K | G50 | G10K
G10K
Provided only for backward compatibility with other R&S signal
generators.
The R&S SMW accepts this value and maps it automatically to
G1K.
*RST: G1K
Manual operation: See "Impedance Clock/Trigger Input" on page 731
[:SOURce<hw>]:INPut:TM:CLOCk:SLOPe <Slope>
Sets the polarity of the active slope of an externally applied clock signal.
Suffix:
SOURce<hw>
.
1 | 2
Determines the baseband the connectors belong to, where:
SOURce1 = Baseband A/C and
SOURce2 = Baseband B/D
Parameters:
<Slope> NEGative | POSitive
*RST: POSitive
Manual operation: See " Clock Input Slope" on page 270
SOURce Subsystem
To Next Page
Loading...