Rohde & Schwarz R&S SMW200A - Page 978

Remote Control Commands
R&S
®
SMW200A
978User Manual 1175.6632.02 ─ 30
TOTal
Couples the deviation of both paths.
RATio
Couples the deviation ratio of both paths
*RST: UNCoupled
Example: See Example "Using combined LF signals" on page 975
Manual operation: See " Deviation Mode" on page 545
[:SOURce<hw>]:PM:DEViation:SUM <PmDevSum>
Sets the total deviation of the LF signal when using combined signal sources in phase
modulation.
Parameters:
<PmDevSum> float
Range: 0 to 20
Increment: 1E-6
*RST: 1
Example: See Example "Using combined LF signals" on page 975
Manual operation: See " Total Deviation" on page 545
[:SOURce<hw>]:PM:RATio <Ratio>
Sets the deviation ratio (path2 to path1) in percent.
Parameters:
<Ratio> float
Range: 0 to 100
Increment: 0.01
*RST: 100
Example: See Example "Performing phase modulation" on page 974.
Manual operation: See " Ratio Path2/Path1" on page 545
[:SOURce<hw>]:PM:SENSitivity?
Queries the sensitivity of the externally applied signal for phase modulation.
The returned value reports the sensitivity in RAD/V. It is assigned to the voltage value
for full modulation of the input.
Return values:
<Sensitivity> float
Example: See Example "Performing phase modulation" on page 974.
Usage: Query only
SOURce Subsystem