Network connections and remote operation
R&S
®
RTM3000
242User Manual 1335.9090.02 ─ 09
IP Port, VXI-11 Port
Specify the IP port number (default = 5025) and the VXI-11 port number (default =
1024).
Remote command:
SYSTem:COMMunicate:INTerface:ETHernet:IPPort on page 600
SYSTem:COMMunicate:INTerface:ETHernet:VXIPort on page 601
Link
"Yes", if the instrument is connected to a local area network via the LAN interface on
the rear panel.
"No", if no LAN connection is detected.
Transfer
Enables automatic transfer speed selection and shows the currently selected value.
Alternatively, you can select one of the predefined settings that corresponds to your
network data rate.
Remote command:
SYSTem:COMMunicate:INTerface:ETHernet:TRANsfer on page 601
MAC, VISA
Show the instrument's media access control address, and the virtual instrument soft-
ware architecture (VISA) address that is used to address the instrument in remote con-
trol.
Remote command:
SYSTem:COMMunicate:INTerface:ETHernet:MACaddress? on page 601
Host name
Shows or specifies the name of the instrument, which the instrument can use to con-
nect to the DHCP server.
Status
Shows the connection status, for example "Allocating network address" or "DHCP, IP
address received".
Password
Specifies an optional password for remote access to the instrument.
Reset
Deletes all IP address settings, and removes the address from the VISA string. All
other settings are set to default values.
Save
Retrieves a DHCP address from the DHCP server or checks the manual IP address,
updates the VISA string, checks connection and saves all settings in the instrument.
LAN connection
To Next Page
Loading...
Need help?
General
