Remote control commands
R&S
®
RTM3000
685User Manual 1335.9090.02 ─ 09
TSHutdown: transmitter shutdown.
OTSHutdown: override transmitter shutdown.
ITERminal: inhibit terminal flag bit.
OITerminal: override inhibit terminal flag bit.
RESet: reset remote terminal.
VECTor: transmit vector word.
RSYNchronize: synchronize with data.
TLAStcmmand: transmit last command word.
BITWord: transmit BIT word.
STSHutdown: selected transmitter shutdown.
OSTShutdown: override selected transmitter shutdown.
*RST:
ANY
TRIGger:A:MILStd:MCODe:VALue
<ModeCode>
Sets the value of the mode code to be triggered on.
Parameters:
<ModeCode>
TRIGger:A:MILStd:MODE <TriggerMode>
Parameters:
<TriggerMode> SYNChronization | FRAME | ERRor | COMMand | STATus |
DATA | CDATa
*RST: SYNC
TRIGger:A:MILStd:RTADdress:CONDition <Compare>
For the RT address, sets the triggering condition for the comparison of the decoded
value to the defined range.
Parameters:
<Compare> EQUal | NEQual | GTHan | GEQual | LEQual | LTHan | WITHin |
OUTSide
*RST: OFF
TRIGger:A:MILStd:RTADdress:MAXimum <AddressMaximum>
Sets the maximum RT address.
Parameters:
<AddressMaximum> 01X-string
TRIGger:A:MILStd:RTADdress:MINimum <AddressMinimum>
Sets the minimum RT address.
Serial bus analysis
To Next Page
Loading...
