Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
699User Manual 1335.9090.02 ─ 09
SEARch:PROTocol:MILStd:SADDress:MCADdress <ModeCodeAddress>
Searches for a mode code address.
Parameters:
<ModeCodeAddress> A0 | A31 | EITHer
*RST: EITH
SEARch:PROTocol:MILStd:SADDress:MINimum <AddressMinimum>
For a subaddress, searches for the minimum address.
Parameters:
<AddressMinimum> 01X-string
SEARch:PROTocol:MILStd:STATus:BCReceived <StatusBit>
Searches for a broadcast received bit of a status word.
Parameters:
<StatusBit> 0 | 1 | X
*RST: X
SEARch:PROTocol:MILStd:STATus:BUSY <StatusBit>
Searches for a busy bit of a status word.
Parameters:
<StatusBit> 0 | 1 | X
*RST: X
SEARch:PROTocol:MILStd:STATus:DBCaccept <StatusBit>
Searches for a dynamic bus control accept bit of a status word.
Parameters:
<StatusBit> 0 | 1 | X
*RST: X
SEARch:PROTocol:MILStd:STATus:INSTrument <StatusBit>
Searches for an instrument bit of a status word.
Parameters:
<StatusBit> 0 | 1 | X
*RST: X
Serial bus analysis