Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
698User Manual 1335.9090.02 ─ 09
SEARch:PROTocol:MILStd:MCODe <ModeCode>
Searches for a mode code type.
Parameters:
<ModeCode> DBControl | TSYNchronize | TSTatus | ISELftest | TSHutdown |
OTSHutdown | ITERminal | OITerminal | RESet | VECTor |
RSYNchronize | TLAStcmmand | BITWord | STSHutdown |
OSTShutdown | ANY
*RST: ANY
SEARch:PROTocol:MILStd:RTADdress:CONDition
<Comparison>
For an RT address, searches for a comparison condition.
Parameters:
<Comparison> OFF | EQUal | NEQual | GTHan | GEQual | LEQual | LTHan |
WITHin | OUTSide
*RST: OFF
SEARch:PROTocol:MILStd:RTADdress:MAXimum <AddressMaximum>
For an RT address, searches for the maximum address.
Parameters:
<AddressMaximum> 01X-string
SEARch:PROTocol:MILStd:RTADdress:MINimum <AddressMinimum>
For an RT address, searches for the minimum address.
Parameters:
<AddressMinimum> 01X-string
SEARch:PROTocol:MILStd:SADDress:CONDition <Comparison>
For a subaddress, searches for a comparison condition.
Parameters:
<Comparison> OFF | EQUal | NEQual | GTHan | GEQual | LEQual | LTHan |
WITHin | OUTSide
*RST: OFF
SEARch:PROTocol:MILStd:SADDress:MAXimum <AddressMaximum>
For a subaddress, searches for the maximum address.
Parameters:
<AddressMaximum> 01X-string
Serial bus analysis