Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
706User Manual 1335.9090.02 ─ 09
TRIGger:A:ARINc:LABel:MAXimum <LabelMaximum>
Specifies the maximum value of the label if TRIGger:A:ARINc:LABel:CONDition
is set to INRange or OORange.
Parameters:
<LabelMaximum> 01X-string
TRIGger:A:ARINc:LABel:MINimum <LabelMinimum>
Sets the minimum value of the label to be triggerd on.
Parameters:
<LabelMinimum> 01X-string
TRIGger:A:ARINc:SDI
<SDIvalue>
Sets the source/destination identifier (SDI) bits to be triggered on.
Parameters:
<SDIvalue> ANY | S00 | S01 | S10 | S11
TRIGger:A:ARINc:SSM <SSMvalue>
Sets the sign/status matrix (SSM) bits to be triggered on.
Parameters:
<SSMvalue> ANY | S00 | S01 | S10 | S11
TRIGger:A:ARINc:TTIMe:CONDition <Compare>
Define the operators for comparison of the decoded transmission time condition with
the specified data.
Parameters:
<Compare> GTHan | LTHan | WITHin | OUTSide
*RST: GTH
TRIGger:A:ARINc:TTIMe:MAXimum <TransmissionTimeMax>
Sets the maximum value of the transmission time.
Parameters:
<TransmissionTimeMax>
TRIGger:A:ARINc:TTIMe:MINimum <TransmissionTimeMin>
Sets the minimum value of the transmission time.
Serial bus analysis