Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
705User Manual 1335.9090.02 ─ 09
TRIGger:A:ARINc:ERRor:GAP <ErrorEnable>
Enables triggering when a gap error occurs.
Parameters:
<ErrorEnable> ON | OFF
*RST: ON
TRIGger:A:ARINc:ERRor:PARity <ErrorEnable>
Enables triggering when a parity error occurs.
Parameters:
<ErrorEnable> ON | OFF
*RST: ON
TRIGger:A:ARINc:FORMat <DataFormat>
Sets the the transmission format to be triggered on.
Parameters:
<DataFormat> DATA | DSSM | DSDI | DSSSm
DSSM: SSM+Data
DSDI: SDI+Data
DSSSm: SSM+Data +SDI
TRIGger:A:ARINc:LABel:CONDition <Compare>
Define the operators for comparison of the decoded label condition with the specified
label.
Parameters:
<Compare> EQUal | NEQual | GTHan | GEQual | LEQual | LTHan | WITHin |
OUTSide
INRange: in range
OORange: out of range
EQUal | NEQual | GTHan | LTHan
Equal, not equal, greater than, less than. These conditions
require one label to be set with TRIGger:A:ARINc:LABel:
MINimum.
INRange | OORange
In range / Out of range: Set the minimum and maximum value of
the range with TRIGger:A:ARINc:LABel:MINimum and
TRIGger:A:ARINc:LABel:MAXimum.
Serial bus analysis