Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
704User Manual 1335.9090.02 ─ 09
INRange: in range
OORange: out of range
EQUal | NEQual | GTHan | LTHan
Equal, not equal, greater than, less than. These conditions
require one data word to be set with TRIGger:A:ARINc:
DATA:MINimum.
INRange | OORange
In range / Out of range: Set the minimum and maximum value of
the range with TRIGger:A:ARINc:DATA:MINimum and
TRIGger:A:ARINc:DATA:MAXimum.
TRIGger:A:ARINc:DATA:MAXimum <DataMaximum>
Specifies the maximum value of the data if TRIGger:A:ARINc:DATA:CONDition is
set to INRange or OORange.
Parameters:
<DataMaximum> 01X-string
TRIGger:A:ARINc:DATA:MINimum <DataMinimum>
Sets the minimum condition for the data.
Parameters:
<DataMinimum> 01X-string
TRIGger:A:ARINc:DATA:OFFSet <DataOffset>
Sets a data offset.
Parameters:
<DataOffset>
TRIGger:A:ARINc:DATA:SIZE <DataSize>
Sets the data size.
Parameters:
<DataSize>
TRIGger:A:ARINc:ERRor:CODing <ErrorEnable>
Enables triggering when a coding error occurs.
Parameters:
<ErrorEnable> ON | OFF
*RST: ON
Serial bus analysis