Rohde & Schwarz RTM3K-COM2

Remote control commands
R&S
®
RTM3000
772User Manual 1335.9090.02 ─ 09
Suffix:
<m>
.
0..15
Number of the logic channel
Parameters:
<Label> String value
String parameter
Example:
DIGital4:LABel "Data"
Defines the label "Data" for logic channel D4.
DIGital<m>:LABel:STATe <State>
Displays or hides the label of the indicated logic channel.
Suffix:
<m>
.
0..15
Number of the logic channel
Parameters:
<State> ON | OFF
*RST: OFF
17.13.1.3 Logic channels - waveform data
For data queries and conversion, consider also the following commands:
●
FORMat[:DATA] on page 569
●
DIGital<m>:DATA:XINCrement? on page 579
●
DIGital<m>:DATA:XORigin? on page 579
●
DIGital<m>:DATA:YINCrement? on page 580
●
DIGital<m>:DATA:YORigin? on page 580
●
DIGital<m>:DATA:YRESolution? on page 580
●
LOGic<p>:DATA:XINCrement? on page 579
●
LOGic<p>:DATA:XORigin? on page 579
●
LOGic<p>:DATA:YINCrement? on page 580
●
LOGic<p>:DATA:YORigin? on page 579
●
LOGic<p>:DATA:YRESolution? on page 580
LOGic<p>:DATA?...........................................................................................................773
DIGital<m>:DATA?.........................................................................................................773
LOGic<p>:DATA:HEADer?..............................................................................................773
DIGital<m>:DATA:HEADer?............................................................................................ 773
LOGic<p>:DATA:POINts................................................................................................. 774
DIGital<m>:DATA:POINts............................................................................................... 774
Mixed signal option (option R&S
RTM-B1)