Schweitzer Engineering Laboratories SEL-421-4 - Page 775

xix
Date Code 20171006 Instruction Manual SEL-400 Series Relays
List of Figures
Figure 18.11 Example COM RTC Command Response ..............................................................................18.39
Figure 18.12 Real-Time Control Application...............................................................................................18.39
Figure 18.13 Local Relay SEL
OGIC Settings ................................................................................................18.40
Figure 18.14 Remote Relay SEL
OGIC Settings.............................................................................................18.40
Figure 18.15 Remote Relay Global Settings.................................................................................................18.40
Figure 18.16 Local Relay Global Settings....................................................................................................18.41
Figure 18.17 Remote Relay Port Settings.....................................................................................................18.41
Figure 18.18 Local Relay Port Settings ........................................................................................................18.41
Figure 18.19 Example COM RTC Command Response ..............................................................................18.42
Figure 19.1 Sample TiDL System Topology ................................................................................................19.2
Figure 19.2 Rear Panel of Relays With TiDL...............................................................................................19.2
Figure 19.3 Axion Chassis ............................................................................................................................19.3
Figure 19.4 SEL-2243 Power Coupler..........................................................................................................19.3
Figure 19.5 SEL-2244-2 Digital Input Module ............................................................................................19.4
Figure 19.6 SEL-2244-5 Fast High-Current Digital Output Module............................................................19.4
Figure 19.7 SEL-2245-42 AC Analog Input Module ...................................................................................19.5
Figure 19.8 Example SV Network................................................................................................................19.6
Figure 19.9 Example Architect SV Publication Configuration ....................................................................19.8
Figure 19.10 SEL-421-7 SV Subscriber Relay, 4U Rear Panel....................................................................19.10
Figure 19.11 Example Architect SV Subscription Configuration ................................................................19.11
Figure B.1 Prepare the Device (Step 1 of 4).................................................................................................B.5
Figure B.2 Load Firmware (Step 2 of 4) ......................................................................................................B.6
Figure B.3 Load Firmware (Step 3 of 4) ......................................................................................................B.7
Figure B.4 Verify Device Settings (Step 4 of 4) ..........................................................................................B.7
Figure B.5 Transferring New Firmware .....................................................................................................B.11
Figure B.6 EtherCAT Cal Board (ECB) FID ............................................................................................ .B.15
Figure B.7 TiDL Interface Board SD Card Slot ........................................................................................ .B.16