Siemens Hicom 112 User Manual

Index
A31003-K16-X001-3-7620
,
07/99
Z-2
Hicom 100 E Version 2.1, Service manual
codes 7-22
display texts 7-18
doorphone setup 7-22
fax/DDI 7-23
incoming calls 7-15
internal traffic 7-18
ISDN parameters 7-19
least cost routing 7-26
networking 7-17
print customer data 7-27
remote administration 7-28
sensors 7-25
station setup 7-12
system data 7-27
system settings 7-21
trunk access 7-13
Codes/extension numbers without the S key
and * or # 7-2
Configuration 4-11
Configuration example for conversion table
8-9
Configuration example for DICS 8-8
Configuration example for single-stage LCR
8-3
Configuration example for two-stage LCR 8-
4
Configuration options 4-17
Configuration stages 2-10
Configuring the system 7-1
Connecting a/b terminals 5-18
Connecting automatic dialler 5-19
Connecting entrance telephones 5-18
Connecting ISDN (S0) interfaces 5-8
Connecting ISDN terminals 5-9
Connecting printer, modem or PC 5-13
Connecting the fax/DDI module 5-19
Connecting the UPS battery cable 5-4
Connecting to ISDN trunk 5-8
Connection options supported within system
environment 2-2
Connection setup via modem for teleservice
7-44
Contact assignment
ALUM module 3-28
EXM/MPPI modules 3-30
fax recognition and DDI module 3-26
GEE module 3-22
PSU/USV1 and PSU/USV2 3-35
S0 Mini Western plug 3-18
SLAS interfaces 3-15, 3-16
STBG module 3-29
STRB module 3-24
TLA 4/2 interfaces 3-19
TLA8 interfaces 3-20
UP0/E interfaces 3-17
Contact assignment for voice modules 11-12
Control relay module - interfaces 3-23
Converting from SW 2.0.2 to SW 2.1 6-21
Cordless solutions 4-12
CorNet-N 4-12, 5-8
Corporate Network LCR (as of V2.0.2) 8-9
Country codes 3-3
Customer data 6-4
Cutover 6-1
D
DDI 3-25
DDI-specific signalling 4-16
Defining intercept criteria
defining intercept, busy 10-55
defining intercept, incomplete DDI num-
ber 10-56
defining intercept, no answer 10-54
defining intercept, recall (as of SW versi-
on 2.0.2) 10-56
defining intercept, unavailable DDI num-
ber 10-55
Defining the number of calls 10-80
Description of features update in SW 2.1 4-
15
Dial-in procedure (previously T-Net) as of
V2.1 8-5
Dialling into the CN 8-6
Dial-tone interpreter 2-10
Digital modem 7-45
Displays 10-68
changing absence messages 10-68
changing message texts 10-68
changing the display language for each

Siemens Hicom 112 Specifications

General

Brand	Siemens
Model	Hicom 112
Category	Telephone
Language	English