Siemens SINUMERIK Series - Page 105

B3: Distributed systems - 840D sl only
2.2 NCU link
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
105
$[LVFRQWDLQHU&7
$VVLJQPHQWSULRUWRURWDWLRQ
$[LVFRQWDLQHU&7
$VVLJQPHQWDIWHUURWDWLRQ
6'61B$;&7B6::,'7+>@ 
6ORW
6ORW
6ORW
6ORW
1&B$;
1&B$;
1&B$;
1&B$;
6ORW
6ORW
6ORW
6ORW
1&B$;
1&B$;
1&B$;
1&B$;
Figure 2-12 Axis container rotation, Fig. 1
Starting with the initial setting, after the rotation with increment 2 (Fig. 2, left-hand side), the
NCU2_ AX1 link axis is assigned to slot 1.
Starting with the initial setting, after the rotation with increment -1 (Fig. 2, right-hand side),
the NCU1_AX2 link axis is assigned to slot 1.
$[LVFRQWDLQHU&7
$VVLJQPHQWDIWHUURWDWLRQ
6'61B$;&7B6::,'7+>@ 
$[LVFRQWDLQHU&7
$VVLJQPHQWDIWHUURWDWLRQ
6'61B$;&7B6::,'7+>@ 
6ORW
6ORW
6ORW
6ORW
1&B$;
1&B$;
1&B$;
1&B$;
6ORW
6ORW
6ORW
6ORW
1&B$;
1&B$;
1&B$;
1&B$;
Figure 2-13 Axis container rotation, Fig. 2
Axis container with container-link axes
The parameterization of an axis container that contains container-link axes must be made on
the master NCU of the link group (MD12510 $MN_NCU_LINKNO == 1).