Siemens SINUMERIK Series

N3: Software cams, position switching cycles - only 840D sl
8.2 Cam signals and cam positions
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
539
rrrrr
3OXV
FDP
0LQXV
FDP
3OXV
FDP
0LQXV
FDP
r




0LQXV
FDPVLJQDO
3OXV
FDPVLJQDO
0DFKLQH
]HUR
0DFKLQHD[LV>P@
!r
0DFKLQHD[LV>Q@
PRGXORURWDU\
D[LV>GHJUHHV@
Figure 8-4 Software cams for modulo rotary axis (plus cam - minus cam > 180 degrees)
8.2.2 Generation of cam signals with gated output
The plus and minus cam output signals are gated in the case of:
● timer-controlled cam signal output to the four onboard outputs on the NCU
● Output to the NCK I/O, if the 2nd byte in the following machine data was not specified (=
"0"):
MD10470 SW_CAM_ASSIGN_FASTOUT_2
...
MD10473 SW_CAM_ASSIGN_FASTOUT_4