H1: Manual and handwheel travel
3.10 Start-up: Handwheels
Extended Functions
202 Function Manual, 03/2013, 6FC5397-1BP40-3BA1
3.10.3 Connection via PROFIBUS (828D)
Parameter assignment
For the SINUMERIK 828D, in addition to the connection of two handwheels to the PPU
interface, terminal X143, a third handwheel can also be connected via a machine control
panel, e.g. MCP 483C PN, interface X60.
The parameter assignment of the third handwheel is performed in the following NCK
machine data:
● MD11350 $MN_HANDWHEEL_SEGMENT[ 2 ] = 5
● MD11351 $MN_HANDWHEEL_MODULE[ 2 ] = 1
● MD11352 $MN_HANDWHEEL_INPUT[ 2 ] = 1
Requirement
Operation of the control with default data (machine data, STEP 7 configuration).
Example
Parameterization of three handwheels, connected via PPU and an "MCP 483C PN" machine
control panel.
Handwheel number
in NCK
Machine data set
(Index)
Connection
1 0 PPU, 1st handwheel in the handwheel slot
2 1 PPU, 2nd handwheel in the handwheel slot
3 2 MCP, 1st handwheel in the handwheel slot
Parameterizing in the NCK machine data:
Machine data Value Meaning
1st handwheel in the NCK
MD11350 $MN_HANDWHEEL_SEGMENT[0] 2 Hardware segment: 8xxD_HW
MD11351 $MN_HANDWHEEL_MODULE[0] 1 ---
MD11352 $MN_HANDWHEEL_INPUT[0] 1 1st handwheel in the handwheel slot
2nd handwheel in the NCK
MD11350 $MN_HANDWHEEL_SEGMENT[1] 2 Hardware segment: 8xxD_HW
MD11351 $MN_HANDWHEEL_MODULE[1] 1 ---
MD11352 $MN_HANDWHEEL_INPUT[1] 2 2nd handwheel in the handwheel slot
3rd handwheel in the NCK
MD11350 $MN_HANDWHEEL_SEGMENT[2] 5 Hardware segment: PROFIBUS
MD11351 $MN_HANDWHEEL_MODULE[2] 1 Reference to logical base address of the handwheel slot of
the MCP
MD11352 $MN_HANDWHEEL_INPUT[2] 1 1st handwheel in the handwheel slot
To Next Page
Loading...
Need help?
General
