H1: Manual and handwheel travel
3.12 Data lists
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
217
Number Identifier: $MA_ Description
32020 JOG_VELO Conventional axis velocity
32040 JOG_REV_VELO_RAPID Revolutional feedrate in JOG mode with rapid traverse
override
32050 JOG_REV_VELO Revolutional feedrate for JOG
32060 POS_AX_VELO Reset position for positioning-axis velocity
32080 HANDWH_MAX_INCR_SIZE Limitation of the selected increment size
32082 HANDWH_MAX_INCR_VELO_SIZE Limitation of the selected increment for velocity override
32084 HANDWH_STOP_COND Behavior, handwheel travel
32090 HANDWH_VELO_OVERLAY_FACTOR Ratio of JOG velocity to handwheel velocity (with DRF)
32300 MAX_AX_ACCEL Maximum axis acceleration
32301 JOG_MAX_ACCEL Maximum axial acceleration for JOG movements
32420 JOG_AND_POS_JERK_ENABLE Initial setting for axial jerk limitation
32430 JOG_AND_POS_MAX_JERK Maximum axial jerk for single axis movements
32431 MAX_AX_JERK Maximum axial jerk for path movements
32436 JOG_MAX_JERK Maximum axial jerk for JOG movements
34210 ENC_REFP_STATE Measuring system status
35130 GEAR_STEP_MAX_VELO_LIMIT[n] Maximum velocity for gear stage
3.12.2 Setting data
3.12.2.1 General setting data
Number Identifier: $SN_ Description
41010 JOG_VAR_INCR_SIZE Size of variable increment for INC/handwheel
41050 JOG_CONT_MODE_LEVELTRIGGRD JOG continuous in inching mode
41100 JOG_REV_IS_ACTIVE Revolutional feedrate in JOG mode active
41110 JOG_SET_VELO JOG velocity for linear axes (for G94)
41120 JOG_REV_SET_VELO JOG velocity (for G95)
41130 JOG_ROT_AX_SET_VELO JOG velocity for rotary axes
41200 JOG_SPIND_SET_VELO JOG velocity for the spindle
To Next Page
Loading...
Need help?
General
