H1: Manual and handwheel travel
3.12 Data lists
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
215
Transverse axes
If a geometry axis is defined as transverse axis:
MD20100 $MC_DIAMETER_AX_DEF (geometry axes with transverse axis function)
and radius programming has been selected, when traversing in JOG, the following features
should be carefully observed:
● Continuous travel:
There are no differences when a transverse axis is traversed continuously.
● Incremental travel:
Only half the distance of the selected increment size is traversed. For example, with
INC10 the axis only traverses 5 increments when the traversing key is pressed.
● Traversing with the handwheel:
As for incremental travel, with the handwheel only half the distance is traversed per
handwheel pulse.
References:
Function Manual Basic Functions; Transverse Axes (P1)
3.12 Data lists
3.12.1 Machine data
3.12.1.1 General machine data
Number Identifier: $MN_ Description
10000 AXCONF_MACHAX_NAME_TAB[n] Machine axis name
10720 OPERATING_MODE_DEFAULT Setting of the operating mode after Power On
10721 OPERATING_MODE_EXTENDED Extended setting of the operating mode after Power On
10735 JOG_MODE_MASK Settings for JOG mode
11300 JOG_INC_MODE_LEVELTRIGGRD INC and REF in inching mode
11310 HANDWH_REVERSE Defines movement in the opposite direction
11320 HANDWH_IMP_PER_LATCH[n] Handwheel pulses per locking position
11324 HANDWH_VDI_REPRESENTATION Coding of the handwheel number (NCK/PLC interface)
11330 JOG_INCR_SIZE_TAB[n] Increment size for INC/handwheel
11340 ENC_HANDWHEEL_SEGMENT_NR Third handwheel: Bus segment
11342 ENC_HANDWHEEL_MODULE_NR Third handwheel: Logical drive number
11344 ENC_HANDWHEEL_INPUT_NR Third handwheel: Encoder interface
11346 HANDWH_TRUE_DISTANCE Handwheel path or velocity specification
11350 HANDWHEEL_SEGMENT[n] Handwheel segment
To Next Page
Loading...
Need help?
General
