M1: Kinematic transformation
6.3 TRACYL cylinder surface transformation (option)
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
371
Machine axis name
MD10000 $MN_AXCONF_MACHAX_NAME_TAB[0]="CM"
MD10000 $MN_AXCONF_MACHAX_NAME_TAB[1]="XM"
MD10000 $MN_AXCONF_MACHAX_NAME_TAB[2]="YM"
MD10000 $MN_AXCONF_MACHAX_NAME_TAB[3]="ZM"
MD10000 $MN_AXCONF_MACHAX_NAME_TAB[4]="ASM"
See also
TRACYL cylinder surface transformation (option) (Page 366)
6.3.2 Specific settings
Setting of the transformation type
The transformation type is set transformation-data-record-specific via:
● $MC_TRAFO_TYPE_<n> = <transformation type>
The user must specify the transformation type for the transformation data blocks. For
TRACYL
a VALUE of 512 must be set for axis configuration 1 and a value of 513 for axis configuration
2 or 514 for transformation with additional linear axis.
The transformation with additional linear axis can be activated with and without groove side
offset (see Section "Switch on (Page 375)").
Transformation type 514 without groove side offset
Cylinder surface curve transformation TRAFO_TYPE_n = 514
If the machine has another linear axis which is perpendicular to both the rotary axis and the
first linear axis, transformation type 514 can be used to apply tool offsets with the real Y axis.
In this case, it is assumed that the working area of the second linear axis is small and will not
be used to execute the part program.
The existing settings for MD10000 $MC_TRAFO_GEOAX_ASSIGN_TAB_n apply.
Grooves with groove side offset
The required inclusion of the tool offset has already been taken into account for the TRACYL
transformation with groove side offset.
Axis image
The following paragraph describes how the transformation axis image is specified.
To Next Page
Loading...
Need help?
General
