P5: Oscillation - only 840D sl
11.4 Marginal conditions
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
665
Special cases
If the PLC input signal "oscillation reversal" is activated as the axis is approaching the start
position, the approach movement is aborted and the axis continues by approach interruption
position 1.
If the PLC input signal "oscillation reversal" is set during a stop period, the stop timer is
deactivated; if exact stop fine has not yet been reached, the axis waits for the exact stop fine
reached signal before continuing its motion.
If the PLC input signal "oscillation reversal" is activated as the axis is approaching the end
position, the approach movement is aborted and oscillation is terminated.
For an example of the external oscillation reversal command (see Section "Change reversal
position via
synchronized action with "external oscillation reversal" (Page 676)").
11.4 Marginal conditions
Availability of the "Oscillation" function
The function is an option ("oscillation functions"), which must be assigned to the hardware
through the license management.
11.5 Examples
Requirements
The examples given below require components of the NC language specified in the sections
entitled:
● Asynchronous oscillation
and
● Oscillation controlled by synchronized actions.
To Next Page
Loading...
Need help?
General
