Siemens SINUMERIK Series

B3: Distributed systems - 840D sl only
2.2 NCU link
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
107
Parameter assignment: NCU1
&KDQQHO
&KDQQHO
VWJHRPHWU\D[LV>@
QGJHRPHWU\D[LV>@
UGJHRPHWU\D[LV>@
/RJLFDOPDFKLQHD[LVLPDJH
6ORWDVVLJQPHQW
&KDQQHO
&KDQQHO
UGFKDQQHOD[LV>@
QGFKDQQHOD[LV>@
VWFKDQQHOD[LV>@
&KDQQHO
&KDQQHO
&KDQQHOD[LVQDPH
0DFKLQHD[HVXVHGLQWKHFKDQQHO
*HRPHWU\D[HVXVHGLQWKHFKDQQHO*HRPHWU\D[LVQDPH
&KDQQHO
&KDQQHO
$[LVFRQWDLQHU&7
0'
0&B$;&21)B*(2$;B1$0(B7$%
0'0&B$;&21)B0$&+$;B86('
0'
0&B$;&21)B&+$1$;B1$0(B7$%
 








0'01B$;&21)B/2*,&B0$&+$;B7$%
0'
01B$;&21)B$66,*1B7$%>@ ಯ1&B$;ರ
01B$;&21)B$66,*1B7$%>@ ಯ1&B$;ರ
01B$;&21)B$66,*1B7$%>@ ಯ1&B$;ರ
01B$;&21)B$66,*1B7$%>@ ಯ1&B$;ರ
&7B6/ &7B6/ &7B6/ &7B6/


1&8
0'
0&B$;&21)B*(2$;B$66,*1B7$%








=
;

=
;

=
;

=
;
1&B$;
1&B$;
1&B$;
1&B$;
6ORW
6ORW
6ORW
6ORW
Figure 2-14 Example: Parameter assignment of channel axes and axis containers
Effect
By programming the X and Z geometry axes in the 1st and 2nd channel of the NCU1, the
following axes traverse in the current position of the container:
● The local AX1 and AX2 machine axes of the NCU1.
● As container-link axes, the AX1 and AX2 machine axes of the NCU2.
For the axis container rotation, see Section "Programming (Page 110)".