Siemens SINUMERIK Series Function Manual

M1: Kinematic transformation
6.2 TRANSMIT face end transformation (option)
Extended Functions
360 Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Transformation selection in pole
If the machining operation must continue from a position on the tool center path which
corresponds to the pole of the activated transformation, then an exit from the pole is
specified for the new transformation.
If
MD24911 $MC_TRANSMIT_POLE_SIDE_FIX_1 = 0
or
MD24951 $MC_TRANSMIT_POLE_SIDE_FIX_2 = 0
is set (pole transition), then a rotation as small as possible is generated at the beginning of
the block originating in the pole. Depending on this rotation, the axis then traverses either in
front of or behind the turning center.
For
MD24911 $MC_TRANSMIT_POLE_SIDE_FIX_1 = 1
or
MD24951 $MC_TRANSMIT_POLE_SIDE_FIX_2 = 1
machining is done before the rotational center point (linear axis in positive traversing range),
for
MD24911 $MC_TRANSMIT_POLE_SIDE_FIX_1 = 2
or
MD24951 $MC_TRANSMIT_POLE_SIDE_FIX_2 = 2
behind the rotational center point (linear axis in negative traversing range).
Transformation selection outside pole
The control system moves the axes involved in the transformation without evaluating
machine data MD24911 $MC_TRANSMIT_POLE_SIDE_FIX_t. In this case, t = 1 stands for
the first and t = 2 for the second TRANSMIT transformation in the channel.

Siemens SINUMERIK Series Specifications

General

Axes Control	Up to 31 axes
Category	Control Unit
Manufacturer	Siemens
Series	SINUMERIK
Control Type	CNC
Communication Interfaces	Ethernet, USB
Operating Temperature	0°C to 45°C
Protection Class	IP20
Power Supply	24V DC
Display	Color TFT LCD