B3: Distributed systems - 840D sl only
2.1 Brief description
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
73
N: SINUMERIK 840D sl, NCU 7x0.3 PN
● Internal SINUMERIK Operate user interface
Because of the existing external SINUMERIK Operate user interface on PCU 50.x in the
system network, the NCU-integrated internal SINUMERIK Operate user interface must be
switched off. The internal SINUMERIK Operate user interface must not be switched off
only when it is used with a limited range of functions, exclusively within the scope of tool
management. Detailed information on this can be found in the Commissioning Manual
"Operator Components and Networking (IM5)", Section "Network configuration" >
"Application example"
● Machine control panel (MCP)
For a flexible switchover of the machine control panels, only one MCP can be connected
to one NCU. The switchover of the MCPs is user-specifically via the PLC user program
(function block FB 9).
Installation and connection
References
● TCU, MCP, PCU:
SINUMERIK 840D sl Operator Components and Networking Manual
● NCU:
SINUMERIK 840D sl NCU 7x0.3 PN Manual
● Machine control panel (MCP)
FB 9: MtoN Control Unit Switchover
● Switch SCALANCE:
Communication with SIMATIC System Manual
Configuration, commissioning and parameter assignment
References
● Structure of the system network and commissioning of a TCU:
Operator Components and Networking Commissioning Manual (IM5)
● Configuration of the channel menu
SINUMERIK Operate Commissioning Manual (IM9), Section "Channel menu"
Programming
References
● MCP:
Basic Functions Function Manual, Section "P3 Basic PLC program for SINUMERIK 840D
sl" > "Block descriptions" > "FB 9: MtoN control unit switchover"
To Next Page
Loading...
Need help?
General
