Symmetricom TimeProvider 5000 User Manual

098-00028-000 Revision F – May, 2012 TimeProvider 5000 User’s Guide 179
Chapter 3
TimeProvider 5000 CLI Command Set
show option
This command displays the option mode and key information.
Command Syntax:
show option
Example:
tp5000> show option
Response:
OPTION SERVICE OPTION KEY KEY VALIDITY
-------------- ---------- ------------
SNMP not available invalid
PTP PROBE not available invalid
Level : User, Config, and Admin
set option
This command sets the option mode and key information. The 6-character key is
printed on the Symmetricom-issued certificate for the unit.
A new license model is used with TP5000 versions 1.2 and later. New features and
options are activated with a 40-character MD5 key. If the user has a 6-character
key, the “set option” command is used to enter the key. If the user has a
40-character key, the “set license” command is used to enter the key.
Command Syntax:
set option snmp <key>
Example:
To enable the snmp option with an authentication key of “ABCDEF”,
tp5000> set option snmp ABCDEF
Level : Config and Admin only
Note: The SNMP feature can either be ordered in a new system, or
added to a previously ordered system as a field upgrade. Contact
your Symmetricom representative for more information.

Symmetricom TimeProvider 5000 Specifications

General

Brand	Symmetricom
Model	TimeProvider 5000
Category	Server
Language	English