WorkCentre 3210/3220 Color Laser Printer Service Manual xv
Data Coupler Information
This equipment complies with Part 68 of the FCC rules and the requirements
adopted by the Administrative Council for Terminal Attachments (ACTA). On
the cover of this equipment is a label that contains, among other information,
a product identifier in the format US:AAAEQ##TXXXX. If requested, this
number must be provided to the telephone company.
A plug and jack used to connect this equipment to the premises wiring and
telephone network must comply with the applicable FCC Part 68 rules and
requirements adopted by the ACTA. A compliant telephone cord and modular
plug is provided with this product. It is designed to be connected to a
compatible modular jack that is also compliant. See installation instructions for
details.
You may safely connect the machine to the following standard modular jack:
USOC RJ-11C using the compliant telephone line cord (with modular plugs)
provided with the installation kit. See installation instructions for details.
The Ringer Equivalence Number (REN) is used to determine the number of
devices that may be connected to a telephone line. Excessive RENs on a
telephone line may result in the devices not ringing in response to an
incoming call. In most but not all areas, the sum of RENs should not exceed
five (5.0). To be certain of the number of devices that may be connected to a
line, as determined by the total RENs, contact the local telephone company.
For products approved after July 23, 2001, the REN for this product is part of
the product identifier that has the format US:AAAEQ##TXXXX. The digits
represented by ## are the REN without a decimal point (e.g, 03 is a REN of
0.3). For earlier products, the REN is separately shown on the label.
To order the correct service from the local telephone company, please provide
the Facility Interface Code (FIC) and Service Order Code (SOC) listed below:
FIC: 02LS2
SOC: 9.0F
You may also have to provide the USOC Jack code and the Ringer
Equivalence Number (REN).
If this Xerox equipment causes harm to the telephone network, the telephone
company will notify you in advance that temporary discontinuance of service
may be required. But if advance notice is not practical, the telephone
company will notify the customer as soon as possible. Also, you will be
advised of your rights to file a complaint with the FCC if you believe it is
necessary.
The telephone company may make changes in its facilities, equipment,
operations or procedures that could affect the operation of the equipment. If
this happens, the telephone company will provide advance notice in order for
you to make necessary modifications to maintain uninterrupted service.
Repairs to the machine should be made only by a Xerox Service
Representative or an authorized Xerox Service Provider. This applies at any
time during or after the service warranty period. If unauthorized repair is
performed, the remainder of the warranty period is null and void. The
equipment must not be used on party lines. Connection to party line service is
subject to state tariffs. Contact the state public utility commission, public
service commission or corporation commission for information.
If your office has specially wired alarm equipment connected to the telephone
line, make sure that the installation of the Xerox equipment does not disable
your alarm equipment. If you have any question about what will disable alarm
equipment, consult your telephone company or a qualified installer.
To Next Page
Loading...
Need help?
General
