Xerox WORKCENTRE 3210 Service Manual

1-24 WorkCentre 3210/3220 Multifunction Printer Service Manual
General Information
Power Save Mode
The Power Save mode is controlled by system firmware. In order to switch the
Ready state to the Power Save mode after a specified time, the main system
sends a sleep command to the engine. When the engine receives a sleep
command, it stops Fuser and Fan operation. The main system then sets the
engine to a sleep state.
The Power Save mode setting is accessed through the Control Panel. The
Power Save can be set from 1 to 120 minutes.
Reports
The following reports are available in the WorkCentre 3210/3220 printer. The
reports can be printed using the printer’s Control Menu or CentreWare IS.
Configuration Report
Two types of Configuration report are available: Printer Configuration report
and Network Configuration report.
Report Print Method
Control Panel CentreWare IS (Network)
Printer Configuration Page Yes Yes
Network Configuration Page Yes Yes
Supplies Information Report Yes No
Fax Phone Book Yes No
Email Address Book Yes No
Email Group Address Book Yes No
Fax Send Report Yes No
Fax Sent Report Yes No
Email Sent Report Yes No
Fax Receive Report Yes No
Schedule Jobs Report Yes No
Junk Fax Report Yes No
User Authentication Report Yes No
Print Cleaning Page Yes No

Xerox WORKCENTRE 3210 Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Print Speed	Up to 24 ppm
Duplex Printing	Manual
Monthly Duty Cycle	Up to 30, 000 pages
Processor Speed	360 MHz
Memory	128 MB
Standard Paper Capacity	250 sheets
Scanner Type	Flatbed, ADF
Fax Transmission Speed	33.6 Kbps
Connectivity	USB 2.0, Ethernet
Media Sizes Supported	A4, A5, B5, Executive, Folio, Legal, Letter
Scan Resolution	Up to 4800 x 4800 dpi
Maximum Paper Size	8.5 x 14 in (Legal)
Operating System Compatibility	Windows, Mac OS
Print Resolution	600 x 600 dpi