Xerox WORKCENTRE 3210 Service Manual

5-6 WorkCentre 3210/3220 Multifunction Printer Service Manual
Print-Quality Troubleshooting
Check the Image
Examine the print to determine the defect type. Match the defect to one or
more of the following examples. Use the accompanying procedure to isolate
or resolve the problem. If the defect persists, go to the troubleshooting
procedure for the observed defect.
1. Print is too light.
a. The toner may be too low. Check the
amount of toner and change the Print
Cartridge if necessary.
b. If you are printing on an rough print
surface, change the media type
settings.
c. Check that the correct type of media is
used.
d. The Print Cartridge may need to be
replaced. Replace the Print Cartridge.
2. Toner smears or print comes off the page.
a. If you are printing on a thick or an
uneven media, change the media type
settings to a heavier type.
b. Check that the media meets
specifications (refer to
“Media and Tray
Specifications” on page 1-18).
3. Toner spots appear on the page and printing is blurred.
a. Run the Clean Drum procedure from
the Maintenance menu.
b. Check the Print Cartridge to make sure
that it is installed correctly.
c. Replace the Print Cartridge.
Light or Undertone Print
Smudges or Smears
Random Spots

Xerox WORKCENTRE 3210 Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Print Speed	Up to 24 ppm
Duplex Printing	Manual
Monthly Duty Cycle	Up to 30, 000 pages
Processor Speed	360 MHz
Memory	128 MB
Standard Paper Capacity	250 sheets
Scanner Type	Flatbed, ADF
Fax Transmission Speed	33.6 Kbps
Connectivity	USB 2.0, Ethernet
Media Sizes Supported	A4, A5, B5, Executive, Folio, Legal, Letter
Scan Resolution	Up to 4800 x 4800 dpi
Maximum Paper Size	8.5 x 14 in (Legal)
Operating System Compatibility	Windows, Mac OS
Print Resolution	600 x 600 dpi