Xerox WORKCENTRE 3210 Service Manual

WorkCentre 3210/3220 Multifunction Printer Service Manual 7-7
Cleaning and Maintenance
Maintenance
RIP Procedures
Perform these maintenance procedures while servicing the printer.
■ Clean the Feed Rollers, Exit Rollers, and Guides; replace if necessary.
■ Remove and clean the paper trays.
■ Print a Configuration and Error History pages; diagnose, and repair any
problems as indicated.
■ Check the printer engine and image processor firmware fans; if
necessary, clean (dust or vacuum) these areas.
■ Check cleanliness of the interior and exterior, including fans; if necessary,
clean (dust or vacuum) these areas.
■ Review proper printer operation using a customer file, if possible. Check
with the customer regarding any special applications they may be using.
■ Review with the customer all work performed and discuss proper printer
care.
Firmware Upgrade Procedures
There are two methods for upgrading firmware, USB and Network.
1. Down load the applicable files from the Xerox support web site. Unzip
(decompress) the files.
2. Be sure your appropriate firmware updating option (Network or USB) is
available and connected.
3. Reboot the printer.
Using a USB Connection
This method uses the Laser MFP Firmware Utility to upgrade the firmware
over a USB connection.
1. Connect PC and printer with a USB Cable.
2. Start the Laser MFP Firmware Update Utility executable file.

Xerox WORKCENTRE 3210 Specifications

General

Print Technology	Laser
Functions	Print, Copy, Scan, Fax
Print Speed	Up to 24 ppm
Duplex Printing	Manual
Monthly Duty Cycle	Up to 30, 000 pages
Processor Speed	360 MHz
Memory	128 MB
Standard Paper Capacity	250 sheets
Scanner Type	Flatbed, ADF
Fax Transmission Speed	33.6 Kbps
Connectivity	USB 2.0, Ethernet
Media Sizes Supported	A4, A5, B5, Executive, Folio, Legal, Letter
Scan Resolution	Up to 4800 x 4800 dpi
Maximum Paper Size	8.5 x 14 in (Legal)
Operating System Compatibility	Windows, Mac OS
Print Resolution	600 x 600 dpi