R3765/67G Series Network Analyzer Operation Manual
8.2 Error Messages
8-6
Operating Error
Duplicate name.
The name that has previously been edited or reserved is input
during {EDIT NAME} operation.
<How to handle>
Input a different name. (Refer to sub-section 7.14.1, 7.14.3,
7.14.4 and 7.14.5.)
File load error.
An error occurred in a {LOAD FILE} execution.
<How to handle>
Something is wrong with the floppy disk, or a file other than files
stored in the R3765/67G series was specified. Check the floppy
disk. (Refer to sub-section 7.14.8.)
File store error.
An error occurred in a {STORE FILE} execution.
<How to handle>
It’s not formatted.
It’s in the state of write protection.
Check the floppy disk. (Refer to sub-section 7.14.3.)
Formatting
failure. Something was wrong in the formatting operation.
<How to handle>
The floppy disk has some scratched.
It’s in the state of write protection.
Check the floppy disk. (Refer to section 7.14.)
Illegal PROG-SWEEP
points.
With the number of total points of all segments being less than 3
or more than 1201, the program sweep was specified.
<How to handle>
Specify the number of the segment point again. (Refer to sub-
section 7.9.2.)
Illegal USER-SWEEP
points.
With the number of total points of all segments being less than 3
or more than 1201, the user frequency sweep was specified.
<How to handle>
Specify the number of the segment point again. (Refer to sub-
section 7.9.2.)
1
2
1
2
To Next Page
Loading...
