FuelsManager Defense
226 Administrator Manual
•
Closeout is defined as one of the following:
Stopping of the movement (either manually OR due to non-
zero flow)
If the movement is active at the system specified closeout
time (default midnight)
Opening Value is defined as one of the following:
If a close out has occurred, the opening value is the value of
the particular variable at the last closeout time.
If the movement has been started but a closeout has not
occurred yet, the opening value is the value of the particular
variable when the movement started.
Closeout Value only exists after a closeout event has occurred. If the
movement remains active, and further closeout events occur
the closeout value will be updated.
Start Value is the value of the particular variable when the movement
was initiated.
The following are possible movement states along with their meanings:
Inactive the movement has been setup but has not been initiated by
the operator.
Active the movement has been initiated by the operator and is not
configured to use Start on Non-Zero Flow.
Disabled the movement cannot be initiated because one or more of
the tanks involved in the movement are currently in use by
another movement and this movement cannot be combined.
Halted the movement has been paused by the operator.
Failed during the start-up of the movement a failure occurred, the
movement is neither active nor inactive. The operator must
use the Reset menu option to clear this state.
To Next Page
Loading...