Definitions
ADM003GVAE1005 227
• A combination that involves the same node pair twice.
• A combination that results in a circular transfer of product.
Starting The movement has been initiated by the operator but the
movement has been configured to Start on Non-Zero Flow
and no flow has been detected yet.
Stopping The movement has been configured to Stop on Non-Zero
Flow and zero flow has not existed for a time greater than
the Zero Flow Hold Off Value.
Combined
Movement
is a combination of movements that involve one or more
common tanks, the following combinations are NOT allowed:
Transfer Tank 1 Tank 2
Blend Tank 1 Tank 3
Tank 2
Charge Tank 1 Unit XYZ
Shipment Tank 2 Unit XYZ
Tank 1
Transfer Tank 1 Tank 2
Transfer Tank 2 Tank 3
Transfer Tank 3 Tank 1
Discrepancy is the difference between the total amount transferred from all
the From tanks and the total amount received at all the To
tanks.
Totals is only available for Shipment and Receipt movements and is
the sum of amount transferred.
To Next Page
Loading...