FuelsManager Defense
364 Administrator Manual
MASS FLOW UNITS - MASS FLOW UNITS
This variable is the engineering units for the tank mass flow process variable. This variable can be viewed from
the Operate interface but cannot be modified
VAPOR DENSITY MININIUM - TANK MINIMUM GAS DENSITY
This variable is the minimum range for the tank gas density process variable. This variable can be viewed from
the Operate interface but cannot be modified
VAPOR DENSITY MAXIMIUM - TANK MAXIMUM GAS DENSITY
This variable is the maximum range for the tank gas density process variable. This variable can be viewed from
the Operate interface but cannot be modified
VAPOR DENSITY UNITS - GAS DENSITY UNITS
This variable is the engineering units for the tank gas density process variable. This variable can be viewed from
the Operate interface but cannot be modified
LEAK RATE MINIMUM - TANK MINIMUM LEAK RATE
This variable sets the minimum leak rate that is detectable when running leak detection tests
LEAK RATE MAXIMUM - TANK MAXIMUM LEAK RATE
This variable sets the maximum leak rate that is allowed when running leak detection tests. Any rate above this
will result in an alarm (if configured) and the printing of the word ‘FAILED’ on leak reports
LEAK RATE UNITS - LEAK RATE UNITS
This variable sets the volumetric engineering units that is used during leak detection
Scaling and Engineering Units Data
To Next Page
Loading...