FuelsManager Defense
368 Administrator Manual
This parameter is used for LPG volume correction methods and defines the radius of the sphere
SHELL THICKNESS
This parameter is used for LPG volume correction methods and defines the thickness of the sphere's shell
LINING MATERIAL
This piece of data stores the material that the tank is coated with on the inside of the tank
DATE INSTALLED
This variable stores the date that the tank was brought into service
TANK MATERIAL
If this parameter defines the material from which the tank shell is constructed. Different materials have different
thermal coefficients of expansion and hence expand or contract at different rates. The selection of tank material
will effect the calculated tank shell correction factor
TANK SHELL CORRECTION - EXPCOEF
This parameter defines the material expansion coefficient used in the tank shell correction calculations. Manual
entry of this value is not allowed except when the Tank Material is set to 'Other'
INSTALL TEMP
This parameter stores the outside ambient temperature when the tank was brought into service
CATHODIC PROTECTION
This variable denotes that this tank is fitted with Cathodic protection--used for reporting and information only
OVERFILL PROTECTION
This variable denotes that this tank is fitted with Overfill protection--used for reporting and information only
SPILL PROTECTION
This variable denotes that this tank is fitted with Cathodic protection--used for reporting and information only
TANK SHELL CORRECTION - ENABLE CORRECTION
If this option is selected FuelsManager compensates the Net Std. volume for the thermal expansion effects of the
tank shell. If the option is not selected the Tank Shell Correction factor equals 1, hence no correction
TANK SHELL CORRECTION - SHELL INSULATION
If this option is selected FuelsManager uses the insulated tank correction equation when compensating the Net
Std. volume for the thermal expansion effects of the tank shell. If the option is not selected the non-insulated tank
correction equation is used
TANK SHELL CORRECTION - AREACOEF
This parameter defines the shell area expansion coefficient used in the tank shell correction calculations.
Manual entry of this value is not allowed except when the Tank Material is set to 'Other'
PRESSURE TRANSMITTER SETUP
Tank Configuration Data
To Next Page
Loading...