FuelsManager Defense
370 Administrator Manual
GAUGE TYPE
This parameter defines the type of automatic tank gauge used by this tank. FuelsManager uses this parameter
for display only. This parameter can be viewed from the Operate interface but cannot be modified
GAUGE TYPE - MODIFIER
This parameter defines the commands available to the operator for a particular automatic tank gauge. For
example,\. Raise / Lower
FLOAT MASS
This parameter is used for LPG volume correction methods where float type automatic tanks gauges are used. It
defines the mass of the float, FuelsManager uses this to compensate the level value reported by the tank gauge
FLOAT DENSITY
This parameter is used for LPG volume correction methods where float type automatic tanks gauges are used. It
defines the density of the float. FuelsManager uses this to compensate the level value reported by the tank
gauge
FLOAT DIAMETER
This parameter is used for LPG volume correction methods where float type automatic tanks gauges are used. It
defines the diameter of the float. FuelsManager uses this to compensate the level value reported by the tank
gauge
STRAPPING TEMPERATURE
This parameter defines the temperature at which the tank strapping table was made. FuelsManager uses this
parameter to correct for roof volume in tanks where the mass of the floating roof has been accounted for in the
strapping table but the current temperature differs from that at which the tank was strapped
STRAPPING DENSITY
This parameter defines the density at which the tank strapping table was made. FuelsManager uses this
parameter to correct for roof volume in tanks where the mass of the floating roof has been accounted for in the
strapping table but the current density differs from that at which the tank was strapped
STRAP TABLE TYPE
This parameter defines whether the strapping table starts at the minimum and increments to the maximum level
/ volume pair (innage) or starts at the maximum level / volume pair and decrements to the minimum (outage)
STRAP/WATER TABLE MODE
This parameter defines the mode of Strap and Water tables used--Combined or Separated. Combined uses a
single table for both water and strap calculations. Separated uses individual tables for strap and water
calculations
POLYNOMIAL SPHERE
This parameter enables the special Polynomial Sphere strapping table when selected in Tank Geometry. The
Polynomial Sphere strapping table uses a polynomial equation to calculate volume based on level
Tank Configuration Data
To Next Page
Loading...