NETS
ENTRIES FOR A NET
178 E
NVOY™ TRANSCEIVER REFERENCE MANUAL
Entries for a NET
NET name
The NET name may be any meaningful name that you want to assign to the NET to
uniquely identify it for selection in the user interface of the control point. The name
may be up to 32 alphanumeric characters including spaces. The NET name is only
used for reference within the transceiver. It is not part of the NET configuration data.
Address
CAUTION: The NET address must be the same for all members of the NET.
The Address entry contains the global address used by all stations that have the NET
programmed in User Data > NETs. The address may be up to 15 alphanumeric
characters (A–Z, 0–9), however, for efficiency of NET calls, it is preferable that the
address be limited to 3 characters. You should choose an address that is not the same
as any self address of members of the NET or wider communication audience.
HF network
CAUTION: The HF network must be the same for all members of the NET.
The HF Network entry defines the scan table(s) containing the channels to be used
with the NET. It is selected from the pre-defined list in HF Networks. You must
select an ALE/CALM HF network for each NET. You can set up two NETs with the
same address but with different HF networks, say one for Group privacy mode and
one for Plain privacy mode. All other entries in the NET can be identical so that calls
may be received via either HF network.
Related links:
Overview of HF networks on page 140
Privacy mode on page 145
To Next Page
Loading...
Need help?
General
