SETTINGS
SETTINGS > CONTROL POINT > TIME AND DATE
ENVOY™ TRANSCEIVER REFERENCE MANUAL 215
Settings > Control Point > Time and Date
The time and date settings for a control point enable you to set the time zone offset
from UTC of the particular control point that you are operating, daylight saving
differences, and time and date formats.
Related links:
Time Zone on page 215
Daylight Saving on page 215
Clock Type on page 215
Time Format on page 215
Date Format on page 216
Setting the time and date on page 40
Time Zone
The Time Zone entry sets the difference between the local time and UTC.
Default value: (+9:30) Adelaide
Daylight Saving
The Daylight Saving entry sets the changes from UTC due to daylight saving.
Available values: Standard time, Summer time
Default value: Standard time
Clock Type
The Clock Type entry sets the type of clock that is shown on the Time and Date
screen to either analogue or digital.
Default value: Analogue
Time Format
The Time Format entry sets whether the transceiver uses a 12-hour or 24-hour
format.
Default value: 12 hour
To Next Page
Loading...
