SETTINGS
SETTINGS > GPS
250 E
NVOY™ TRANSCEIVER REFERENCE MANUAL
Settings > GPS
The GPS settings enable you to set up how the transceiver handles GPS information.
Related links:
GPS Detection Timeout on page 250
GPS Show Options on page 250
GPS Format Options on page 251
My Position on page 252
GPS Detection Timeout
The GPS Detection Timeout entry sets the time the transceiver waits to receive
updated GPS information before it shows an error message. The GPS Detection
Timeout entry is only active when the GPS Call option is installed.
NOTE: You cannot make Send Position calls until the transceiver receives
valid GPS information. If you send an Emergency call before valid
GPS information is received, the last known position is sent with the
call. If you receive a Get Position call, the last known position is
returned to the caller.
When valid GPS data is received, a message is shown on the screen to inform you of
this.
If your transceiver is using static GPS information in the My Position entry, set the
GPS Detection Timeout entry to Disabled.
Available values: Disabled, range specified below
Range: 5 to 30 min
Default value: 10 min
GPS Show Options
The GPS Show Options entry sets whether or not altitude and speed information
is shown on the GPS screen and user-status area. By default, altitude and speed data
are hidden.
Available values: Show altitude, Show speed
Default value: no selection
To Next Page
Loading...
Need help?
General
