EasyManuals Logo

Codan Envoy Reference Manual

Codan Envoy
537 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #201 background imageLoading...
Page #201 background image
NETS
ENTRIES FOR A NET
E
NVOY™ TRANSCEIVER REFERENCE MANUAL 179
NET members
CAUTION: The list of NET members must be the same for all members of the
NET.
The NET Members entry contains a sequential list of the self addresses of up to
20 members of the NET. The station uses this list to calculate the response slots, so
each station in the NET can determine when an automatic response is required after
the start of the call. A member’s self address may be up to 15 alphanumeric characters,
however, for efficiency of NET calls, it is preferable that each member self address be
limited to 3 characters. To preserve an empty slot use the null address (@@@) in a
NET member position, for example, a station may be removed from NET Members,
but you want the timing of response slots at other stations to remain the same.
NOTE: You can have the NET programmed in your transceiver, but you are
only a member of the NET if your self address is included in the NET
Members entry.
Out calls
The Out Calls entry enables you to set up your station to make calls to the NET, or
disable calling to the NET. Unless you need to restrict calling to the NET, you should
set the Out Calls entry to Enabled for all stations in the NET, regardless of their
member status.
If you want to set up your NET so that only one station makes calls to the NET, set
the Out Calls entry for the NET in that station to Enabled. Set the Out Calls entry
for all other stations with this NET programmed to Disabled.
In calls
CAUTION: If the Link entry is set to Only if response, you must ensure that at
least one member station is set to receive an incoming call from the
NET and send a response to the link request.
The In Calls entry enables you to set up your station to receive all incoming calls
from the NET, to receive calls only if you are a member of the NET, or to ignore calls
from the NET.
If your station:
has the NET programmed and you want to receive calls from the NET, select
Enabled
has the NET programmed but you are not a member, and you do not want to
receive any of the NET calls, select Members only
NOTE: As your station is not a member of the NET, it will not enter the
link.
is a member of the NET but you do not want to receive any calls from the NET,
select Disabled

Table of Contents

Other manuals for Codan Envoy

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Codan Envoy and is the answer not in the manual?

Codan Envoy Specifications

General IconGeneral
BrandCodan
ModelEnvoy
CategoryTransceiver
LanguageEnglish

Related product manuals