SETTINGS
SETTINGS > CALLING > GENERAL
230 ENVOY™ TRANSCEIVER REFERENCE MANUAL
Settings > Calling > General
The general calling settings enable you to set up how the transceiver behaves when it
receives certain calls, and how it performs an action when activity is detected on a
channel that you want to use. The general calling settings also include a number of
alarms and timeouts.
Related links:
Call Types For Contacts on page 230
Call Types For New Call on page 231
Show Phone Link Address on page 231
Emergency Call Alarm on page 231
Message Call Alarm on page 232
Selective Call Alarm on page 232
External Alarm on page 232
Alert Tones on page 233
Call Status Time on page 233
Chain Call Pause on page 233
In Call Timeout on page 234
LBT Mode on page 234
LBT Period on page 235
LBT Data Sensitivity on page 235
LBT Waveform on page 235
Respond GPS on page 236
Respond OTA on page 237
Call Types For Contacts
The Call Types For Contacts entry sets the call types that are available for
selection when adding or editing call information for a contact.
Available values: Selective, Channel Test, Message, Get Position, Send Position,
Phone, Get Status, Emergency, RFDS Emergency, Marine Emergency, ALE
Sounding
NOTE: The call types available depend on the options installed in your
transceiver.
Default value: all available call types selected
Related links:
Adding a contact on page 163
Call types on page 434
To Next Page
Loading...
Need help?
General
