DATA OPTIONS
2.4 KBIT/S DATA MODEM
ENVOY™ TRANSCEIVER REFERENCE MANUAL 303
Setting up the USB connection
NOTE: The USB–USB connection for data communications is recommended
for base stations only.
CAUTION: Ensure that the peripheral device on the 15-way connector is not set to
2.4 kbit/s Data Modem Interface.
Viewing the COM port setting in VCOM
VCOM provides virtual serial COM ports to enable serial protocols to be used over
other protocols, for example, USB and Ethernet. VCOM operates on Windows® XP,
Vista and 7.
When VCOM launches, it assigns a virtual COM port for use by internal devices in
the Envoy™ Transceiver. This port number must be set up in other programs used for
data communication over HF and secure key programming.
To view the virtual COM port setting:
1 Launch VCOM Configuration from Start > All Programs > Codan >
VCOM.
1 Record the value of the COM port used for the device in the Connected
Services frame.
This value is entered as the COM port in the relevant application
communicating with the Envoy™ Transceiver.
NOTE: CICS is used for secure key programming via KMS and KFS.
1 Click Done to close the VCOM Configuration utility.
To Next Page
Loading...
Need help?
General
