SETTINGS
SETTINGS > CONNECTIVITY
ENVOY™ TRANSCEIVER REFERENCE MANUAL 259
Related links:
DHCP Client on page 259
DHCP Client
The DHCP Client entry sets whether or not there is a DHCP client active on this
control point. Typically, the DHCP client is enabled if the control point is connected
to a computer network that has a DHCP server enabled. If the DHCP client is enabled,
it overrides any IP, network mask or gateway value that may have been entered
manually.
Default value: Disabled
Default Gateway
The Default Gateway entry sets the IPv4 address of the default gateway for the
control point. If you have set the DHCP Client entry to Enabled, this entry is
ignored.
Default value: 192.168.0.1
USB IP Address
The USB IP Address entry sets the IPv4 address for the USB interface on the
control point. The USB interface on the control point can also act as a DHCP server.
CAUTION: It is recommended that this setting is not changed.
Default value: 192.168.234.1
USB Network Mask
The USB Network Mask entry sets the network mask for the USB interface on the
control point.
CAUTION: It is recommended that this setting is not changed.
Default value: 255.255.255.0
USB DHCP Server
The USB DHCP Server entry sets whether or not there is a DHCP server active on
the USB interface for this control point. The server provides IP addresses to any
IP-based USB devices that have a DHCP client enabled.
CAUTION: It is recommended that this setting is not changed.
Default value: Enabled
To Next Page
Loading...
Need help?
General
