SETTINGS
SETTINGS > CONTROL POINT > GENERAL
206 ENVOY™ TRANSCEIVER REFERENCE MANUAL
Welcome Text
The Welcome Text entry sets the text that is shown on the screen during power up.
You can store up to three lines of text. Each line may have up to 20 characters of text.
If a welcome image is set, this image is shown first, followed by the welcome text. If
text is entered in the Local Welcome Text entry, it overrides the text in the
Welcome Text entry.
Default value: no selection
Related links:
Local Welcome Text on page 208
USB User Access
The USB User Access entry sets the actions that can be performed at user level
when a memory stick is inserted in the USB connector on the control point.
NOTE: A profile is an electronic file that contains all the user-defined and
operational settings that control a transceiver system.
If you want to enable the user to:
• load a profile into the transceiver, select Program profile to transceiver
• read a profile from the transceiver, select Read profile from transceiver
• upgrade the firmware in the transceiver, select Firmware upgrade
• program secure keys to the transceiver, select Program secure keys to
transceiver
Default value: no selection
Channel Scroll
The Channel Scroll entry sets the direction in which the key scrolls through the
channels, that is, to the next channel or the previous channel.
Available values: Go to next channel, Go to previous channel
Default value: Go to next channel
To Next Page
Loading...
