CHANNELS
WORKING WITH CHANNELS
ENVOY™ TRANSCEIVER REFERENCE MANUAL 123
Working with channels
Related links:
Entries for a channel on page 119
Overview of scan tables on page 128
Available modes on page 282
Tx Power on page 221
Navigating the menu structure on page 92
Entering text in a field on page 103
Selecting a value from a list on page 107
Saving your changes on page 111
Adding a channel in free tune on page 287
Adding a channel
Stations in an HF communication network use the information contained within a
channel to transmit and receive signals. Common channel information must be
programmed into transceivers that want to communicate with each other. Typically,
these channels are grouped into scan tables, which are allocated to an HF network.
NOTE: If you are operating the transceiver in a country that has stringent
licensing regulations, you may not be permitted to add channels with
transmit frequencies.
NOTE: If the TxD option is installed in the transceiver, there are restrictions on
the frequencies that you can enter.
NOTE: If the TxP option is installed in the transceiver, you cannot add
channels.
NOTE: You may be permitted to add a channel in free tune.
To add a channel:
1 From the main menu, select (User Data), then (Channels).
NOTE: You can also select (Add Channel) from the main menu to
directly enter a channel. This channel will be placed in the list of
channels in alphanumeric order.
To Next Page
Loading...
Need help?
General
