Codan Envoy Reference Manual

SETTINGS
SETTINGS > CONTROL POINT > STATUS AREA
212 ENVOY™ TRANSCEIVER REFERENCE MANUAL
Settings > Control Point > Status Area
The status area settings for a control point enable you to customise the information
that is shown on the channel screen of the control point that you are operating. There
are six areas that can show information ranging from call information, address
information, functional information, and user-defined text.
Figure 47: Status areas
Related links:
Selecting information to be shown in a status area on page 28
Status Area 1 on page 212
Status Area 2 on page 212
Status Area 3 on page 213
Status Area 4 on page 213
Status Area 5 on page 213
Status Area 6 on page 213
User-defined Text 1 on page 213
User-defined Text 2 on page 214
Status Area 1
The Status Area 1 entry sets the information that is shown at the middle left of the
screen. If a voice encryptor is active, the secure status overwrites your selection for
this status area.
Default value: no selection
Status Area 2
The Status Area 2 entry sets the information that is shown at the middle right of the
screen. If a data encryptor is active, the secure status overwrites your selection for this
status area.
Default value: no selection
status area 1 status area 2
status area 3
status area 5 status area 6
status area 4

Codan Envoy Specifications

General

Brand	Codan
Model	Envoy
Category	Transceiver
Language	English