SETTINGS
SETTINGS > CONTROL POINT > CONSOLE
ENVOY™ TRANSCEIVER REFERENCE MANUAL 217
Settings > Control Point > Console
The console settings for a control point enable you to customise the behaviour of the
desk console that you are using as the control point.
Related links:
Console Location on page 217
Internal Speaker on page 217
Console PTT on page 218
Foot-switch PTT on page 218
Console External Alarm on page 218
Console Easitalk Start State on page 218
Console Location
The Console Location entry sets whether the desk console is connected to the
transceiver directly or via the Ethernet.
If the desk console:
• is connected to the RFU using cable 08-07205-00x, select Local
• is connected to the RFU using an Ethernet cable (08-07215-001), select
Remote
CAUTION: You must set this value correctly to ensure that the desk console
switches off and on.
Default value: Local
NOTE: A remote installation requires a separate PSU for the desk console.
NOTE: When the value is set to Remote, the desk console does not switch off
the RFU when it is switched off.
Related links:
Setting the location of the desk console on page 43
Internal Speaker
The Internal Speaker entry sets whether or not the internal speaker in the desk
console is active.
Default value: Enabled
To Next Page
Loading...
Need help?
General
