SETTINGS
SETTINGS > CONTROL POINT > STATUS AREA
ENVOY™ TRANSCEIVER REFERENCE MANUAL 213
Status Area 3
The Status Area 3 entry sets the information that is shown just below the middle left
of the screen.
Default value: Time
Status Area 4
The Status Area 4 entry sets the information that is shown just below the middle
right of the screen.
Default value: 2.4 kbit/s Data Modem throughput
NOTE: The throughput indicator is only shown if the 2.4 kbit/s Data Modem
Interface option is enabled in the firmware.
Status Area 5
The Status Area 5 entry sets the information that is shown at the bottom left of the
screen.
Default value: Last received call
Status Area 6
The Status Area 6 entry sets the information that is shown at the bottom right of the
screen.
Default value: no selection
User-defined Text 1
The User-defined Text 1 entry defines the text that you want to have shown on the
screen. This text may be assigned to any of the status areas by selecting the
User-defined Text 1 value for the status area. You may enter up to 16 alphanumeric
characters.
Default value: no selection
To Next Page
Loading...
Need help?
General
