PERIPHERALS
ENTRIES FOR A PERIPHERAL
ENVOY™ TRANSCEIVER REFERENCE MANUAL 201
RFU 15way 2.4 kbit/s Data Modem Interface
The RFU 15way 2.4 kbit/s Data Modem Interface entry sets whether or not this
internal data modem interface is connected to the 15-way port. If you are connecting
to a computer with UUPlus© via serial cable 08-06952-00x, you must set this to
Enabled.
Default value: Disabled
RFU 6way Mode
The RFU 6way Mode entry sets the mode in which the RS232 6-way serial port
operates. This entry is only available if you are setting up the 6-way connector on the
RFU for a user-defined peripheral device.
If the port is:
• not in use, select None
• receiving GPS information, select GPS
• controlling and monitoring the transceiver, select CICS
• accessing information from a log of radio/telephone interconnect activity, select
Log output
Default value: GPS
RFU 6way Speed
The RFU 6way Speed entry sets the data rate of the RS232 6-way serial port. If
available, you should set this to the same speed that is set in the connected peripheral
device.
Default value: 4800 bit/s
RFU 6way Startup
The RFU 6way Startup entry sets the serial commands that you want to have
performed by the 6-way port following power up.
Typically, this is used for specific commands that are required in a system that uses
CICS commands.
Default value: no selection
To Next Page
Loading...
