SETTINGS
SETTINGS > CONNECTIVITY
260 ENVOY™ TRANSCEIVER REFERENCE MANUAL
RFU IP Address
The RFU IP Address entry sets the IPv4 address for the RFU. If you have multiple
RFUs on a computer network, you must set a different IP address for each RFU, or
enable the DHCP client in the RFU. If the RFU DHCP Client entry is set to
Enabled, this entry is ignored.
Default value: 192.168.0.248
RFU Alias
The RFU Alias entry sets the network alias for the RFU. If you have multiple RFUs
connected to a computer network, you can identify them with a meaningful name.
Default value: RFU
RFU Network Mask
The RFU Network Mask entry sets the network mask for the RFU. If you have set
the RFU DHCP Client entry to Enabled, this entry is ignored.
Default value: 255.255.255.0
RFU DHCP Client
The RFU DHCP Client entry sets whether or not there is a DHCP client active on
the RFU. Typically, the DHCP client is enabled if the RFU is connected to a computer
network that has a DHCP server enabled. If the DHCP client in the RFU is enabled, it
overrides any IP, network mask or gateway value that may have been entered
manually.
Default value: Disabled
RFU Default Gateway
The RFU Default Gateway entry sets the IPv4 address of the default gateway for
the RFU. If you have set the RFU DHCP Client entry to Enabled, this entry is
ignored.
Default value: 192.168.0.1
To Next Page
Loading...
Need help?
General
